FE Civil practice exam


Free FE Civil practice exam
A highway crest vertical curve has , , . If the design stopping sight distance is , the minimum length required for safety is most nearly:
A BOD5 test uses seeded dilution water. A 5 mL sample is placed in a 300 mL BOD bottle and filled to volume with seeded dilution water. The diluted sample has an initial dissolved oxygen (DO) of 8.2 mg/L and a DO of 3.0 mg/L after 5 days of incubation. A seed control bottle, prepared with a larger dose of the same seed and no sample, has an initial DO of 9.0 mg/L and a DO of 5.0 mg/L after 5 days. The ratio f of the seed in the sample bottle to the seed in the seed control bottle is 0.05. What is the BOD5 of the sample, in mg/L?
Recrystallization temperature is estimated as , where is the absolute melting temperature (K). The melting point of steel is approximately . The estimated recrystallization temperature of steel, in degrees Celsius, is most nearly:
Which of the following functions is odd?
A triangular notch has an included angle of and head of . The discharge (in ) with coefficient is most nearly:
During an elastic collision between two bodies of different masses:
A compound horizontal curve consists of two simple circular curves. The total deflection angle between the back and forward tangents is . The first curve has and a deflection angle of . The second curve has . The length of the second curve (ft) is most nearly:
The Brinell hardness test uses:
A construction crew excavates a trench 12 ft deep in Type B soil, with a trench bottom width of 6 ft. Using the OSHA maximum allowable slope ratio for Type B soil, determine the minimum required width of the excavation at the ground surface.
A rectangular beam wide and deep is reinforced with # bars at an effective depth of . Concrete strength , and steel strength . The nominal flexural strength (in ft-kips) is most nearly:
A compound curve has radii and with total deflection . The length of the second curve if first deflection is most nearly:
The beam shown below is best classified as:
Achievable
A 5 m steel rod is unrestrained and free to expand or contract. It is heated from 20°C to 90°C. Using a coefficient of thermal expansion of 12 × 10⁻⁶ /°C for the steel, determine the free change in length of the rod.
For a rectangular cross section bending about the vertical axis (bending about weak axis), the points of maximum normal stress are:
In the truss shown, the force in the member is most nearly:
Achievable
A simply supported beam of span carries a uniformly distributed load of . The maximum bending moment is most nearly:
A car traveling at on level pavement with reaction time of and friction coefficient . The total stopping sight distance is most nearly:
The bending stress in a beam is given by:
A diameter pipe carries a velocity of . The discharge (in MGD) is most nearly:
For a given loading, soil conditions, and design life, which pavement type generally requires the greatest thickness?
According to ACI 318, the minimum clear spacing between parallel reinforcing bars in a single horizontal layer in a beam should not be less than:
A block of wood with specific gravity floats in water. The volume submerged () is:
A soil has permeability , hydraulic gradient , and cross-sectional area . The discharge is most nearly:
Which of the following improves corrosion resistance of steel?
A traffic signal cycle length is with effective green . The capacity of the approach with saturation flow veh/hr/ln is most nearly:
A closed traverse has a perimeter of 1,000 ft. When the raw latitudes and departures are summed, the latitudes total +0.60 ft and the departures total +0.80 ft. The compass (Bowditch) rule distributes each misclosure among the courses in proportion to course length. Using this rule, determine the latitude correction to be applied to a course whose length is 250 ft so that the traverse closes.
A survey line has a bearing of S 35° W. What is the azimuth of this line, measured clockwise from north?
A manufacturer incurs fixed costs of $150,000 per year to produce a single product. The product sells for $75 per unit, and the variable cost is $50 per unit. Determine the annual production quantity at which total revenue equals total cost.
The most commonly used admixture to increase workability is:
The center of pressure of a vertical rectangular gate submerged in water lies:
A borrow soil for a highway embankment has voids and a specific gravity of . The approximate dry unit weight (in ) of the soil is most nearly:
An engineer receives annually for years. If the interest rate is , the present value of this annuity is most nearly:
An earthwork mass diagram plots cumulative volume (cut positive, shrinkage-adjusted fill negative, in cubic yards) against station along a proposed roadway. The cumulative ordinate at each station is:
Station 0+00: 0 cy Station 5+00: +3,000 cy Station 10+00: -500 cy Station 15+00: +3,000 cy Station 20+00: +1,000 cy
Between which two stations can all cut be used as fill within that stretch, without hauling material into or out of it from elsewhere on the project?
An engineer plots the shear and bending moment diagrams for a beam. For the first half of the span the engineer uses the standard sign convention (positive shear = clockwise rotation on the left face of the cut section; positive moment = sagging, concave up). Partway through the beam, the engineer switches to the opposite convention for the remaining segments. Compared to using one convention consistently over the whole beam, what happens to the shear and moment values calculated for the remaining segments?
A contractor's excavator has an hourly ownership cost (depreciation, interest, insurance, taxes, and storage) of $34/hr and an hourly operating cost (fuel, lubricants, tires, and repairs) of $22/hr. The operator is paid $30/hr, and the excavator produces 80 cubic yards of material per hour. Determine the unit cost of production, in dollars per cubic yard, for the excavator and its operator.
A conflict of interest arises when:
A triaxial test on sand shows failure at , . The friction angle is most nearly:
A trapezoidal channel has a bottom width of , depth of , and side slope of . The wetted perimeter is most nearly:
The time of concentration of a small urban catchment is . If the rainfall intensity corresponding to this duration is and , the peak runoff (in cfs) for acres is most nearly:
For a fully submerged vertical plane surface, the total hydrostatic force depends on:
The maximum shear stress theory is also called:
A contractor is placing a concrete slab 60 ft long, 30 ft wide, and 6 in thick. The estimator adds a 5% waste factor to the calculated volume, and ready-mix concrete is ordered only in whole cubic yards (rounded up). What quantity of concrete should be ordered?
Euler’s formula for buckling load is valid for:
A horizontal force of just starts to move a block of weight . The coefficient of static friction is most nearly:
The hourly operating cost of a truck is and the ownership cost is . If the truck works , the annual cost of the truck is most nearly:
The purpose of a performance bond in construction is to:
A firm is planning to save every year for years. If the interest rate is , what is the future worth of these savings?
For the simply supported beam with span and load applied at midspan, the deflection at midspan is:
A filter backwash rate is . If the filter area is and the backwash duration is , the backwash water used (in gallons) is most nearly:
Which of the following is a solution to ?
A pendulum of length swings from rest through a vertical height of . The speed at its lowest point (in ) is most nearly:
A triangular direct runoff hydrograph (DRH) has a base of and a peak discharge of . The catchment area is . The effective rainfall (in cm) is most nearly:
A building pad is graded using the unit-area (grid) method, V = (A/4)(Σh1 + 2Σh2 + 3Σh3 + 4Σh4), where A is the area of one grid square and hn is the cut depth at a grid point shared by n squares. The site is divided into four equal 20 ft × 20 ft squares, forming a 3×3 array of survey grid points. The cut depth (ft) measured at each point is:
Row 1 (north edge): 3, 5, 4 Row 2 (middle row): 5, 7, 6 Row 3 (south edge): 4, 6, 5
What is the total volume of cut, in cubic feet?
A block slides down a smooth incline of height. Its speed at the bottom (in ) is most nearly:
A contractor develops a bid estimate with the following direct costs: labor = $120,000; materials = $180,000; equipment = $50,000; subcontracts = $150,000. Field and home-office overhead is added at 10% of the total direct cost. Profit is then added at 8% of the sum of direct cost plus overhead. Determine the total bid price.
A smooth sphere sits in a symmetric V-shaped groove (two planes at equal angle ). Which statement about contact forces is true?
The slump test is used to measure:
For a rectangular beam, the stress block depth is given by . If and , the stress block depth is most nearly:
Soundness of cement is tested by:
A piece of equipment costing has a salvage value of after years. If the annual maintenance cost is and the interest rate is , the equivalent uniform annual cost is most nearly:
A truck hauls per trip and requires for a complete cycle. The hourly production of the truck is most nearly:
A function is continuous at if:
The discharge through a venturi meter is . If the throat diameter is , the velocity at throat () is most nearly:
A project has a net present value (NPV) of and an internal rate of return (IRR) of . If the discount rate is , what is the most appropriate decision?
Find the dot product of and :
A borrow pit soil has a dry unit weight of and a natural water content of . The total unit weight of the soil is most nearly:
A freeway with flow , average speed . The space headway () between vehicles is most nearly:
A structural engineer designs an office building under a written contract with the building owner. Two years after completion, a decorative cornice element, negligently detailed by the engineer, detaches and injures a pedestrian walking on the public sidewalk below. The pedestrian was never a party to any agreement with the engineer. Under which legal theory can the pedestrian pursue a claim against the engineer?
A beam fixed at both ends carries a uniform load . The maximum moment is:
Match each beam type with the correct description:
Beam A: Simply supported beam with uniform load Beam B: Continuous beam with spans Beam C: Cantilever beam with end point load Beam D: Beam fixed at both ends
Descriptions:
- Simple-span
- Multispan
- Cantilever
- Fixed-end
A water storage tank is designed for an average demand of and must provide hours of storage. The required volume (in gallons) is most nearly:
A design team has completed roughly 30 percent of the construction documents for a building project—enough to size the major structural, mechanical, and electrical systems—but the drawings and specifications are not yet complete. Which type of construction estimate is most appropriate at this stage, and what is it based on?
A rectangular beam is reinforced with # bars (). Section width , effective depth . For and , the (in ft-kips) is most nearly:
A simple vertical curve has , , . The grade change rate per station is most nearly:
A flood-frequency analysis estimates a -year peak discharge of . The probability of exceedance in any given year is:
For laminar flow in a circular pipe, the head loss is proportional to:
A ladder rests against a smooth vertical wall, and the ground is rough. Which of the following correctly lists all the forces acting on the ladder?
The superelevation required for a curve with design speed and radius (assume ) is most nearly:
The ability of a material to absorb energy and deform plastically before fracture is:
The cross section of a doubly symmetric steel I-beam is subjected to bending about the strong axis. The maximum bending stress occurs at:
A pipe of length and diameter conveys water at a velocity of . The Darcy–Weisbach friction factor is . The head loss (in m) is most nearly:
The vector cross product of and is:
The limit is:
The ratio of lateral strain to longitudinal strain is:
What is the equation of a line passing through with slope ?
A survey line of is measured with a steel tape that is actually long. The corrected length of the line is most nearly:
A water treatment plant has a chlorine contact tank of volume . If the flow is , the detention time (in minutes) is most nearly:
A simply supported beam of span carries a central point load of . The maximum bending moment is most nearly:
At two-way stop-controlled (TWSC) intersections, the sight distance required for a stopped vehicle to complete a left-turn maneuver onto the major road is governed primarily by which sight-distance criterion?
A normally consolidated clay has , , and thickness . If effective stress increases from to , the primary consolidation settlement is most nearly:
The centroid of a semicircular area of radius , measured from the flat diameter toward the curved edge, is given by:
Which of the following statements is true about standard normal distribution?
A cyclist increases speed uniformly from to in seconds. The distance traveled (in ) in this time is most nearly:
A thick sand layer has , . The Rankine active earth pressure at the base of the layer is most nearly:
A survey crew runs differential leveling from benchmark BM1 (elevation = 100.00 ft) to benchmark BM2, using one turning point, TP1. The rod readings recorded in the field book are: backsight on BM1 = 4.25 ft; foresight on TP1 = 6.10 ft; backsight on TP1 = 5.80 ft; foresight on BM2 = 3.40 ft. What is the elevation of BM2?
A beam wide overall depth is reinforced with # bars () at an effective depth of . With and , the design moment strength (in ft-kips) is most nearly:
A normally consolidated clay layer , , , is loaded from to . The settlement is most nearly:
A sand has relative density , , . The void ratio is most nearly:
A retaining wall high has , . The active thrust per foot of wall is most nearly:
Which of the following is not a basic component of a valid contract?
A joint in a truss connects three members; two are collinear and the third is non-collinear. If no external force acts at that joint, which member(s) are zero-force?
A wide strip footing is placed at depth on sand with , , . The ultimate bearing capacity is most nearly:
When working with a multidisciplinary team, the engineer’s primary responsibility is to:
A particle is acted upon by forces of , , and directed along , , and respectively. The magnitude of the resultant is most nearly:
A triangular notch has an included angle of and a discharge coefficient . If the head over the notch is , the discharge (in L/s) is most nearly:
A structural element is in a plane stress state with σx = 80 MPa, σy = 20 MPa, and τxy = 30 MPa. Determine the maximum in-plane shear stress.
A freeway lane operates at capacity flow of veh/hr/ln with density veh/mi/ln. The average speed (mph) is most nearly:
A thick clay has , . If effective stress increases from to , the settlement is most nearly:
If the mean of five numbers is and four of them are , , , and , what is the fifth number?
A cantilever beam carries a point load of at the free end. The maximum deflection at the free end is:
